Setting up a Brick Paver Walkway or Aac Bricks

The usage of Bricks or Pavers to produce a walkway or patio area complements a home in a way that is unmatched. In addition, setting up a Brick or Paver walkway does not necessarily need a pro.

The key to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be set up. In addition, string lines should be strung on each side of the walkway.
When the area has been dug down, 3/4" gravel stone need to be laid in and tamped down securely. The height in between the tamped down sand and the stringline ought to equate to the density of the brick or paver.

Now that you have a stable base, place a 1" pipeline or journal board the length of the pathway on either side of the pathway. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will serve as your pathway border and help to maintain the stability and shape of the pathway. You can get these plastic strip borders at a lot of home improvement shops. The strips need to be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

The key to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the integrity of the walkway.

Undoubtedly bricks/pavers will need to be cut or split when constructing the walkway. Unless you want to buy or lease an expensive wetsaw, I would suggest buying a basic brick/paver splitter. It is essentially a sculpt with a large end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of website sand and place the sculpt at a 75 degree angle over the area where you wish to break the brick. Utilizing a hammer strike the butt end of the sculpt strongly. You might require to do this a number of times. You might also want to flip the brick/paver over and strike the other side of the brick using the hammer and chisle. Within one or two strikes the brick/paver must break easily. , if your pathway has curves you will need to buy/rent a wetsaw.

.

After setting up the bricks, develop the outside edges with additional sand, and after that shovel in the topsoil and pack down securely.
Spread stone dust over the brand-new sidewalk and sweep into the cracks. This will complete the interlocking of the bricks and assist to get rid of any weed growth.


In addition, setting up a Brick or Paver walkway does not always require a pro. The key to installing a Brick or Paver Walkway is to very first correctly prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipe or journal board the length of the pathway on either side of the sidewalk. These strips will act as your walkway border and aid to maintain the integrity and shape of the walkway. Inevitably bricks/pavers will require to be cut or divided when developing the sidewalk.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Setting up a Brick Paver Walkway or Aac Bricks”

Leave a Reply

Gravatar